Ben, <div><br></div><div> Thanks so much for your response.  While trying to trace down where the 22K resistor was on the PCB, I noticed that I installed the electrolytic connected to the volume pot backwards...I'm usually very careful about that sort of thing, so I'm not sure how that happened. But maybe that was the cause of the pop! I reversed that cap and changed the power source anyway as you suggested, and the pop is gone now. </div><div><br></div><div>I'd like to make a correction to my prior comments about the transistor pin-out.  They are all ECB and clearly marked on each body, but I must have been seeing that as EBC.  Maybe reversing the cap doesn't sound so unlikely after all.  </div><div><br></div><div>Now I have one or two more tasks before I can send this back.  I don't hear any snare at all, and the white noise adjustment trimmer (4.7K on this early model) only seems to pass signal when fully-CW.  Maybe the two issues are connected somehow, but I'm definitely hearing the cymbals so I'm getting signal from Q9 to Q14. </div><div><br></div><div>Thanks again</div><div><br></div><div>Nick</div>