<div dir="ltr">So I was trying to get a reading on my breadboard to see how much voltage was lost between the input of three passive low pass filters in series and the output. <div><br></div><div>My measurements between ground and:</div><div>positive supply: 5.06 V</div><div>Output from chip: 2.4 V (was expecting 5 V because digital square wave)<br></div><div>junction of first and second resistor: 2.4 V</div><div>junction between second and third resistor: 2.4 V</div><div>after third resistor: 2.4 V ....</div><div><br></div><div>All resistors measured at 5.07 kOhms. I'm not sure what's going on. Is my breadboard messed up somehow or am I missing something fundamental about electronics?</div></div>