<div dir="ltr">Hey all....<div><br></div><div>So I breadboarded this up: <a href="http://gaje.jp/blog/wp-content/uploads/2011/12/ms_type_vca.png">http://gaje.jp/blog/wp-content/uploads/2011/12/ms_type_vca.png</a></div><div><br></div><div>I used a 2N3904 and didn't have an op amp buffer so went without it. the CV input was provided by the two diode, two resistor and a cap AD generator.</div><div><br></div><div>And no sound.</div><div><br></div><div>Now with the labeling of 2.5V I'm guessing that the circuit is being run off of a 0-5V power supply and the 2.5V is acting as a virtual ground. Since I don't have the op amp in my circuit, I just went with connecting those 2.5V bits to ground. </div><div><br></div><div>I'm going to be putting together a bipolar power supply this weekend, so I'll give it another go then.</div><div><br></div><div>Also, my 2N3904 could be fried. The bag of them has taken a spill a couple times and I've had to scoop them up by hand and put them back....</div><div><br></div><div>Tips, tricks, and scathing criticisms welcome as always</div></div>