<div dir="ltr">Hey all,<div><br></div><div>I was going back through Jacob Watters article about the CMOS synth and a bit that I had previously passed over caught my eye... </div><div><br></div><div>He has the signal passing through a pot (I'm assuming in one end out the other end) and then a switch from a 4066 connecting the wiper to a capacitor to ground. The 4066 switch is clocked by a simple 40106 oscillator flipping back and forth between the plain signal and a low passed version.</div><div><br></div><div>Being mildly obsessed with the tone circuit of the Big Muff Pi pedal, I thought it would be cool to apply this filter switching to that circuit. The low pass side would work the same way, putting the switch between the resistor and the capacitor, but I'm not sure if that would work for the high pass side. I don't know THAT much about the nuts and bolts of electronics. <br><br>My other option if that doesn't work out so well in the breadboard, is to just put the switches in the signal path right before the filters. My thought was either have a separate oscillator clocking each switch or have one oscillator clocking one switch and then sending the same oscillator output to the other switch through an inverter. </div><div><br></div><div>Thoughts? Anything glaringly stupid about the idea?</div><div><br></div><div>-Ian</div></div>