450v is high for modern electrolytics. You can use two lower voltage and larger capacitance caps in series with balance resistors if necessary.<br><br>You didn't say what the capacitance was, but you might be able to find plastic film caps with a large enough capacitance. Power factor correction capacitors (PFC) are film-foil construction, up to 450VAC and low loss, but they are likely to be physically much larger than the equivalently rated electrolytic capacitors.<br><br>Anything marked low-ESR and rated 105'C  from the likes of Panasonic, Rubycon, Vishay/BC components, or Nippon-Chemicon should be decent quality.<br><br>-Richie,<br><br>P.S. Be careful, the stored energy is very likely lethal at those voltages!<br><br>Sent from my Xperia SP on O2<br><br>---- cheater00 . wrote ----<br><br>Hi guys,<div>I have to replace the DC HV filter capacitors on my Mesa head. They're 450V electrolytics running at maybe 420V and have a footprint of 12mm at the base. They dried out after ~6 years. I would like to replace them with good ones that have very low ESR in the audio range. This amp has a problem where gain stages leak to each other, and I suspect that happens through the HV bus. If need be I can use capacitors with a different footprint, I could build a scaffold since everything is TH.</div><div><br></div><div>Is there anything that would suggest against using MKT capacitors here?</div><div><br></div><div>I also thought about using pairs of large and small capacitor to compliment frequency response of impedance.</div><div><br></div><div>Links to suppliers or part #'s would be great.</div><div><br></div><div>Thanks</div>