<div dir="ltr"><div><div></div>I've been doing work with SIMs, and there's some chips which can be used to drive SIMs (and also do voltage translation) at 1.8, 3 and 5V.<br><br></div>LTC1555 springs to mind - although I'm not sure if it can drive 20mA (it's maximum drive is between 50mA and 100mA according to its datasheet).<br></div><br><div class="gmail_quote"><div dir="ltr">On Tue, 27 Oct 2015 at 15:05 Nils Pipenbrinck <<a href="mailto:n.pipenbrinck@hilbert-space.de">n.pipenbrinck@hilbert-space.de</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">Not strictly synth related but...<br>
<br>
<br>
In one of my projects I want a low impedance power supply that can<br>
either source 3V or 1.8V. The load is kind of weak, it's a CPLD IO bank<br>
that I'm going to power, so 20mA would fit my bill, 50mA would be better.<br>
<br>
The voltages itself are available as well, with required current source<br>
capabilities.<br>
<br>
At first I thought: Just generate the voltages from my microcontroller<br>
with a resistor divider and run that through an opamp voltage follower<br>
to generate the current, but no: My load requires decoupling capacitors<br>
and opamps don't like capacitive loads. Those who can cost a fortune.<br>
<br>
Then I thought: Screw it, I'll just take a ordinary adjustable 3<br>
terminal LDO and switch one of the voltage defining resistors. That does<br>
not work either because LDOs can only source current, not sink any. If I<br>
switch from 3V to 1.8V the output voltage will just stay high until I've<br>
consumed enough energy to drop it down.<br>
<br>
<br>
So, any idea how to buffer a reference voltage in a way that is fine<br>
with capacitive loads? I searched long and hard on the internet but<br>
haven't found anything cheap with low part count.<br>
<br>
Probably also good to know:<br>
<br>
 - I have an additional voltage-source of 5V available.<br>
 - input/reference voltage won't be modulated. It's either 3V or 1.8V.<br>
 - I don't need super fast switching. It is okay for the output voltage<br>
to take a quater second to reach it's final voltage.<br>
<br>
<br>
Best,<br>
  Nils<br>
_______________________________________________<br>
Synth-diy mailing list<br>
<a href="mailto:Synth-diy@dropmix.xs4all.nl" target="_blank">Synth-diy@dropmix.xs4all.nl</a><br>
<a href="http://dropmix.xs4all.nl/mailman/listinfo/synth-diy" rel="noreferrer" target="_blank">http://dropmix.xs4all.nl/mailman/listinfo/synth-diy</a><br>
</blockquote></div>