<DIV style="font-family:Arial, sans-serif; font-size:10pt;"><P><FONT face="Arial, sans-serif">Modern LEDs only need 2ma-4ma to be bright.</FONT></P><P><BR></P><P>Paul S.</P><P><BR><BR>--- rick.jansen@xs4all.nl wrote:<BR><BR>From: Rick Jansen <rick.jansen@xs4all.nl><BR>To: Synth-Diy <synth-diy@dropmix.xs4all.nl><BR>Subject: [sdiy] 7-segment LED displays with 4511 driver chip - max current?<BR>Date: Wed, 05 Aug 2015 18:32:10 +0200<BR><BR>
  
  
    <FONT face="Arial">I need three 7-segment digits for a small
      project, and am looking at the common 4511 driver to drive them.
      There are numerous examples around of circuits to do just that,
      but I'm a bit puzzled. The specs for the 4511 say that it can
      source 25 mA max current, per pin. However, with a max total of 50
      mA for the entire package. So, if you light ALL segments, excluding
      the dot, that would be 50/7 = 7 mA max current per segment. <BR>
      <BR>
      Only TI says 7.5 mA explicitly : <A href="http://www.ti.com/lit/ds/symlink/cd74hc4511.pdf">http://www.ti.com/lit/ds/symlink/cd74hc4511.pdf</A><BR>
      NXP: <A href="http://www.nxp.com/documents/data_sheet/HEF4511B.pdf">http://www.nxp.com/documents/data_sheet/HEF4511B.pdf</A><BR>
      <BR>
      A very common value in available circuits for the current limiting
      R is 470Ω, which gives ca 10 mA, but which would exceed the total
      current for the package. Even 220Ω is common, which indeed
      delivers 20 mA to one LED segment, but may fry the 4511 if you
      light 7 segments with 140 mA.<BR>
      <BR>
      How do you use the 4511?<BR>
      <BR>
      thanks<BR>
      <BR>
      rick<BR>
      <BR>
    </FONT>
  

_______________________________________________
Synth-diy mailing list
<A href="/eonapps/ft/wm/page/compose?send_to=Synth-diy%40dropmix.xs4all.nl">Synth-diy@dropmix.xs4all.nl</A>
<A href="http://dropmix.xs4all.nl/mailman/listinfo/synth-diy">http://dropmix.xs4all.nl/mailman/listinfo/synth-diy</A>
</P></DIV>