Heh.  Minor, new problem. :P  Haha. :D<br><br>I've got all 4 of the rotary switches hooked up again.  I ran into a small problem.  Whilst all 4 of them cycling away are sounding great - together they're about 99.5% in tune with each other.  :(
<br><br>One thought that I had, was to add a trimmer resistor, just before the 1K resistor to Ground.<br><br>I tried a 200 ohm 20 turn trimmer, with an 820 ohm resistor replacing the 1K.  Nope.  Almost, but not quite.<br>
<br>I tried a 500 ohm 20 turn trimmer, thinking that it would help me get that little bit of extra range.  Nope.  I finally realized that the extra resistance that I'm putting in, is acting JUST like a TUNING pot! :O  The frequency ratio is still the SAME right across.  There was no difference in tuning between the 1st and 12th position on the rotary, whether I had 820 ohms at the bottom, or 820 + 500 ohms at the bottom.
<br>Ahhhh!  So TUNING, WILL work on this version!  :D<br><br>But now - how, do I get the ratio set exactly?  My only thoughts so far, are 0.1% each of the 1% resistors, around each rotary.  I THINK, that should take care of it.  Giving an even division between each step on the rotary.  No?
<br><br>Also - my trouble COULD be - not having tuned the 1V/octave trimmer in the Constant Current Source - EXACTLY.  (I'd rushed, on the 1st rotary set up.)  I'm going to go back, and trim it to beat free on 1 trimmer for the 1st and 12th positions, and see where that takes me. :)
<br><br>Another new trouble - using the LM329 6.9V reference with the Constant Current Source - is dropping my main output voltage to 1.6V. :O :O  That only allows me enough resistance to drop the source 1 more volt.  (Unless I go into -V.  Can I, without troubles??)
<br>I'm wondering if I should move up to a 10V source.  (Which I don't have anything FOR, at the moment - unless I can do the same thing as the LM329 with an LM723, variable regulator.)<br><br>Anyhoo ..... I'm still pleased as punch. :)  Once I have my new maple panels in, I'll be mounting the PCB to it - and completing the sequencer, finally.  I don't wish to mount it to my prototyping pegboard, as I'll just have to rip it all out again, to move into the Maple panel. :(  And with the sequencer; 7 bit divider; S&H; white noise and 2 logic gates on this board - it'll be a LOT to transfer. :P
<br><br>Come on maple - hurry up and get here!  :D  LOL<br><br>-- <br>Take care,<br>Warmth and Peace,<br>Ryk<br><br><a href="http://deathlehem.bravehost.com/damian.html">http://deathlehem.bravehost.com/damian.html</a> - D.A.M.I.A.N
.;s webpage - Jan. 0406 update