<div><span class="gmail_quote">On 12/4/05, <b class="gmail_sendername">Aaron Lanterman</b> <<a href="mailto:lanterma@ece.gatech.edu">lanterma@ece.gatech.edu</a>> wrote:</span>
<blockquote class="gmail_quote" style="PADDING-LEFT: 1ex; MARGIN: 0px 0px 0px 0.8ex; BORDER-LEFT: #ccc 1px solid"><br>If I need four op amps in a circuit, any reason I wouldn't just grab a<br>quad op amp chip?<br><br>For instance, all over the OB-Mx board, you'll find TL072s... why use so
<br>many of them when you could use fewer TL074s?<br><br>- Aaron<br><br>-----------------------------------------------------------------------------<br><br>Dr. Aaron Lanterman, Asst. Prof.       Voice:  404-385-2548<br>School of Electrical and Comp. Eng.    Fax:    404-894-8363
<br>Georgia Institute of Technology        E-mail: <a href="mailto:lanterma@ece.gatech.edu">lanterma@ece.gatech.edu</a><br>Mail Code 0250                         Web:    <a href="http://users.ece.gatech.edu/~lanterma">users.ece.gatech.edu/~lanterma
</a><br>Atlanta, GA 30332                      Office: GCATT 334B<br><br></blockquote></div>
<div> </div>
<div>*************************************<br>I asked the same question a while back. Basically, there are two reasons. One: to avoid coupling that might occur between amps in the same package with high voltage and/or high current swings. Two: There are many cases where using two duals instead of a single quad makes the PCB routing easier.
</div>
<div> </div>
<div> </div>
<div>Tim (although I can't say I've ever seen an OB-Mx board) Servo<br clear="all">-- <br>"Imagination is more important than knowledge." - Albert Einstein </div>