Hi Grant,<br>
<br>
I removed the HPF slider pot and it tested OK - around 1Meg at its
maximum extension, which is the position it needs to be in for the HPF
lowest setting. Sweeping the HPF does exentuate the tilt, so I had come
to the conclusion that it was HPF related. Somebody also suggested that
there may be a problem with a DC blocking cap, so I'm going to replace
all of the tantalum caps when I can summon enough enthusiasm to pull
the whole thing apart again.<br>
<br>
I've  managed to do all the board A and B calibrations and it's
sounding a lot better than when I got it, so for now, I think I can
probably live with this square wave problem.<br>
<br>
Cheers,<br>
Chris<br><br><div><span class="gmail_quote">On 11/29/05, <b class="gmail_sendername">Grant Richter</b> <<a href="mailto:grichter@asapnet.net">grichter@asapnet.net</a>> wrote:</span><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
You don't mention what frequency you are talking about.<br>The amount of tilt should vary with frequency.<br>My guess:<br>The high pass filter section is not going to it's lowest setting.<br>What you are describing is simply the effects of high pass filtering
<br>(the one after the low pass before the VCA).<br>The cap or slide pot may be bad.<br><br>On Nov 26, 2005, at 8:56 AM, Chris Kay wrote:<br><br>> Hi,  I have an Ody MKII (2813) which I 've been trying to<br>> calibrate. If I set it up as follows:
<br>><br>> osc. 1 keyboard tracking on<br>> osc. 2 sync off<br>> PW slider fully down<br>> filter freq. slider fully up<br>> VCA gain slider fully up<br>> osc. 1 (or 2) to audio fully up<br>> all other sliders down
<br>><br>> I've noticed that when I monitor the high gain output with a scope<br>> and send a square wave from one of the osc's, I don't get a square<br>> wave out. I get something that resembles a shark's tooth pattern
<br>> and doesn't sound square, it's sort of buzzy, not hollow. I've<br>> calibrated both square wave ouputs from board B(II) using the osc.<br>> PW trimmers to get nice looking 50% pulse waves.<br>><br>> Further more, when I select the sawtooth on either osc. and monitor
<br>> the high gain, I don't really get the classic ramp, rather an<br>> initial spike followed by an exponential downward curve with some<br>> small 'wobbles' on the tail. Again the sawtooth output from board B<br>
> looks like a nice classic sawtooth.<br>><br>> Clearly something's happening to the signal in board C(II). Does<br>> anybody have any ideas? All suggestions gratefully accepted.<br>><br>> Cheers<br>> Chris
<br><br></blockquote></div><br>