<div>  I have a K2000 that has been non-working for a few years now. Turned on power. Blew fuse. Replaced fuse. Blew again.</div>
<div>It seems others have seen this same problem. The only helpful thing I could find was the following post:</div>
<div> </div>
<div>> Kurzweil uses linear power supplies. Chances are one or more diodes in the<br>> bridge rectifier have shorted, causing AC to be fed to the DC smoothing<br>> capacitors, which have a low Equivalent Series Resistance and look like a
<br>> near dead short at 60 hertz. This type of failure is likely and the<br>probably<br>> cause of blown fuses.<br>> Diodes fail for two reasons: power surge and inrush surge at power on. A<br>> surge arrestor may cure problem #1, but the best remedy for #2 is to avoid
<br>> frequent power cycling, thus reducing your chances of diode failure.<br>> If it were my unit, I'd get a VOM and buzz out the diodes (after<br>> disconnecting power and also the transformer secondary coil from the diode
<br>> bridge) and see which are shorted. They can probably be replaced with off<br>> the shelf varieties available at Radio Shack, etc.<br>> Failing that, it's off to factory service. And if it's a new unit under
<br>> warranty, that's the way to go.</div>
<div> </div>
<div> </div>
<div>  Tested the diodes and three of them measure 0.530 or there abouts. One measures 0.0001 so I'm guessing this needs replacement.</div>
<div>It is a 1N5401. I'm wondering if this might be the proper fix/ diagnosis? </div>
<div> </div>
<div>Any thoughts, suggestions, comments, experiences greatly appreciated.</div>
<div> </div>
<div>Thanks,</div>
<div>peng</div>