<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML dir=ltr><HEAD>
<META http-equiv=Content-Type content="text/html; charset=iso-8859-1">
<META content="MSHTML 6.00.2800.1479" name=GENERATOR></HEAD>
<BODY>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2>Dan,</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff size=2>Not 
likely that the cap has failed as it as it would have to have failed by changing 
it's capacitance to a much "greater" value than stock, also the faders are 
getting notorious as time goes by.  Because the faders are relatively 
"cheap" models side to side action (most inadvertent from moving or brushing 
with the hand) slowly causes the housing to loosen up.  If this is the case 
the "wiper" of the pot isn't always in contact and it performs as if the pot is 
all the way "on".   Dirt could also cause the "wiper" to not make 
contact.  </FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff size=2>I 
would try to clean it with std contact spray (you'll get lot's of opinions on 
what is best to clean pot's but in this case contact cleaner is a good 
start).  Give it a good bath.  If this doesn't fix it then you may 
have to remove the slider caps, un-screw the top housing.  If you do this, 
look at the glide pot and check to see if the housing is "loose".  If so 
carefully look at it and find where you can use pliers to re-seat the 
housing.  Test it to see if it is now working.</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff size=2>While 
your in there, and if you think you audio level is too low (as many do) remove 
R102.  Instructions regarding this can be found at:</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff size=2><A 
href="http://www.geocities.com/gallomagnetix/mg1x.html">http://www.geocities.com/gallomagnetix/mg1x.html</A></FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff size=2>good 
luck.</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2>regards,</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2>p</FONT></SPAN></DIV>
<DIV><SPAN class=610095216-05022005><FONT face=Arial color=#0000ff 
size=2></FONT></SPAN> </DIV>
<DIV class=OutlookMessageHeader dir=ltr align=left><FONT face=Tahoma 
size=2>-----Original Message-----<BR><B>From:</B> 
owner-synth-diy@dropmix.xs4all.nl 
[mailto:owner-synth-diy@dropmix.xs4all.nl]<B>On Behalf Of </B>Schierl, 
Dan<BR><B>Sent:</B> Friday, February 04, 2005 9:53 PM<BR><B>To:</B> 
synth-diy@dropmix.xs4all.nl<BR><B>Subject:</B> [sdiy] MG-1 
question<BR><BR></FONT></DIV>
<DIV><FONT face=Arial color=#000000 size=2>hi list!</FONT></DIV>
<DIV><FONT face=Arial size=2></FONT> </DIV>
<DIV><FONT face=Arial size=2>i have a couple problems I'm trying to work out, 
but the one I wanted to ask you folks about is this issue I've had with my MG-1 
for quite awhile. very frequently, I've noticed that the "Glide" control acts 
like its turned all the way up when really, its not. i can't quite tell what 
sets it off, but once in awhile the machine acts like it just drank a bunch of 
cough syrup. I've looked at the schematic and I'm thinking somethings up with 
either the slider R63 or cap C13, but wanted to know if anybody has experienced 
this sort of behavior before I go swapping stuff out. Oddly, a friend of mine 
with his own MG1 is having the same problem, so if anyone has any thoughts on 
the matter, y'all could make me look really cool in front of my friends if i can 
get this fixed. thanks!</FONT></DIV></BODY></HTML>