[sdiy] Installing good looking XLR panel connector on rack equipment?

[cheater cheater]

I have a couple dbx 286s units, and in their infinite wisdom dbx did
not include XLR output, only input, so I'm looking for a good clean
way to install a high quality xlr output plug. It already has balanced
TRS, so electrically it isn't anything spectacular, but I'm looking to
punch the enclosure in a nice way and then install the plug. I was
wondering if anyone had experience with this, and can recommend a good
combination of panel mount XLR jack and a punch that makes holes that
fit it well. I know Neutrik do panel mount XLR, so that would be my
go-to, but I don't know how best to go about doing the hole punching,
so I would appreciate any suggestions or experiences. Thanks.