[sdiy] Covers / shroud for unused header pins?

[David Huss]

If it was just for the workshop I'd get a suitable female connector, cut & grind off the pins and dip the top into plastidip.

Alternatively you should just try to treat powered electrical circuits like raw eggs and ensure your benchtop is spacious/cleared enough that such accidents become less likely.

On September 6, 2024 3:45:50 PM UTC, Mattias Rickardsson <mr at analogue.org> wrote:
>How could you ever work with electronics without having stuff powered on?
>
>(Try powering off your computers, software guys out there)  ;-)
>
>/mr
>
>Den fre 6 sep. 2024 16:34Florian Anwander <fanwander at mnet-online.de> skrev:
>
>> Hello
>>
>> Am 06.09.24 um 14:17 schrieb cheater cheater via Synth-diy:
>>
>> i'm still confused as to how unplugging a thing from the wall is too
>> difficult
>>
>> hmmm, when I am repairing a device and I have to do measurements or
>> trimming, I will have to open and close the lid a hundred times to change
>> settings on the frontpanel and then get back inside to continue my
>> measurement. Of course I don't want to unplug or switch off the device, for
>> each move of the lid...
>>
>> Florian
>> ________________________________________________________
>> This is the Synth-diy mailing list
>> Submit email to: Synth-diy at synth-diy.org
>> View archive at: https://synth-diy.org/pipermail/synth-diy/
>> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
>> Selling or trading? Use marketplace at synth-diy.org
>>