[sdiy] Pro-One screws and jack nuts

[Mike Bryant]

A tape measure in the picture might help
________________________________
From: Synth-diy <synth-diy-bounces at synth-diy.org> on behalf of Tom Wiltshire <tom at electricdruid.net>
Sent: 06 October 2024 19:19
To: Sean Ellis via Synth-diy <Synth-diy at synth-diy.org>
Subject: [sdiy] Pro-One screws and jack nuts

Does anyone know what size the screws in the wooden end panels of the Sequential Pro-One are? Bonus points if you know what size the nuts for the back panel jacks are too!

I'm asking so I don't have to pay $15 + $15 shipping (+ taxes on $30 when it hits the EU border) from Wine Country Sequential. €40 for four screws and four nuts is just stupid prices, sorry.

https://sequentialcircuits.com/images/600_Pro1.screws.jpg

https://sequentialcircuits.com/prooneparts.html

Many thanks,
Tom

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20241006/d19cfae5/attachment.htm>