[sdiy] OB8 power transformer
Adam (synthDIY)
synthdiy at adambaby.com
Wed Jun 5 06:39:17 CEST 2024
Greg you haven't noticed any increased noise on the audio bus?
(There's an option for doing this to my Jupiter 8, but I'm wary...)
A
> On 5 Jun 2024, at 1:00 pm, g m montalbano via Synth-diy <synth-diy at synth-diy.org> wrote:
>
> This is indeed the most likely explanation. I've ditched the suspect transformer and decided to try the switching PS replacement (as has been done with the Prophet VS, Rhodes Chroma and others).
> Made a few modifications to the CPU board (cut some traces, removed some original power supply components) and wired up a Meanwell multi-output switching supply.
> So far, all is good -- runs quiet, cool, and no bootup or memory problems. If any do show up, will inform the list; otherwise, considering this one done.
> Thanks to all who replied to the original post.
> ~GMM
>
> On Mon, May 27, 2024 at 1:24 AM Tony Allgood via Synth-diy <synth-diy at synth-diy.org <mailto:synth-diy at synth-diy.org>> wrote:
>> > An intermittent shorted turn ?
>>
>> That would be my conclusion too. I had a five year old Peavey guitar amp
>> in for repair. It was initially fine for about half an hour and then
>> would take out the mains inlet fuse. Changing the fuse, it would work
>> only for five minutes or so before blowing again.
>>
>> I concluded that as the transformer naturally warmed up the physical
>> size would change and maybe some loose windings would slightly shift
>> causing the wires to rub against each other. The wire's insulation
>> coating may have been weak at some point and eventually, kaboom.
>>
>> I also had a transformer in an old Logan String Melody that would not
>> fail but, after three or four hours of being powered up, would get
>> stupidly hot (with accompanying 'warm electronics' smell). Testing it in
>> isolation on the bench all seemed fine but I found it was very slowly
>> heating up. If one wasn't specifically looking for excessive heat rise
>> you wouldn't notice anything untoward until the unit had been powered
>> for at least two hours - even with no load applied to the secondaries.
>> In this case I assumed it was due to losses within the laminated core
>> rather than any shorted turns.
>>
>> Tony
>>
>> New album out: https://takla-makan.bandcamp.com/album/solway-firth
>> ________________________________________________________
>> This is the Synth-diy mailing list
>> Submit email to: Synth-diy at synth-diy.org <mailto:Synth-diy at synth-diy.org>
>> View archive at: https://synth-diy.org/pipermail/synth-diy/
>> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
>> Selling or trading? Use marketplace at synth-diy.org <mailto:marketplace at synth-diy.org>
> ________________________________________________________
> This is the Synth-diy mailing list
> Submit email to: Synth-diy at synth-diy.org
> View archive at: https://synth-diy.org/pipermail/synth-diy/
> Check your settings at: https://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20240605/51962f8c/attachment.htm>
More information about the Synth-diy
mailing list