[sdiy] Powering 4ms pod

[Jay Schwichtenberg]

Some power supplies need a load before they function properly. So you 
might try that on the +/-12 and +5 if available.

Jay S.

On 11/10/2022 1:45 PM, Didier Leplae via Synth-diy wrote:
> Ok, so now I got the actual 4ms power supply from Thomann and I am still having the same problem!
> There are no modules or even ribbon cables plugged into the pod. The power flashes on and off. However, I didn’t measure this accurately, but using my «one-one thousand» method, I estimate it is flashing every two seconds and with the other power supply it was about every second.
> The last power supply was 90W and this one is 45W.
> I’m not sure if that is at all helpful to figure out what is going on.
> I guess either the pod is defective or was damaged somehow, or the last power supply set off this problem?
>
> Any ideas?
>
>> On Nov 2, 2022, at 5:36 PM, Gerry Murray via Synth-diy <synth-diy at synth-diy.org> wrote:
>>
>> :-)
>>
>>> On 02/11/2022 17:28, Didier Leplae wrote:
>>> We’ll, I managed to return the power supply, so might never know why that didn’t work…
>>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
>> http://synth-diy.org/mailman/listinfo/synth-diy
>> Selling or trading? Use marketplace at synth-diy.org
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org