[sdiy] Amphenol edge card connector sides touch?
valery.klapatsiuk at gmail.com
Tue Mar 22 15:26:41 CET 2022
I checked several Amphenol 225-22821-*101* connectors I have – none of the
contacts on them are shorting...
вт, 22 мар. 2022 г. в 16:02, mark verbos via Synth-diy <
synth-diy at synth-diy.org>:
> Definitely not. The power is shut down by the shorting.
> I have had some success putting my wide tweezers into the slot and pushing
> back and forth.
> > On 19. Mar 2022, at 19:39, Brian Willoughby <brianw at audiobanshee.com>
> > This matches computer edge card connector circuits I've seen from a
> certain era, but now you have me wondering:
> > Was the Buchla 200 series designed for this shorting of opposed
> terminals? I've never owned one...
> > Brian
> > On Mar 19, 2022, at 09:35, Oren Leavitt wrote:
> >> Yes. The terminal pairs normally short on these type connectors when
> cards are removed. At least all that I've seen. Power supply lines are
> usually connected with same voltage on each terminal pair or one side not
> >> Best bet may be to put a dummy card in unused connectors.
> >> - Oren
> >> On 3/19/22 8:02 AM, mark verbos wrote:
> >>> Hi there,
> >>> I have a Buchla 208 I built from parts from Buchla’s garage sale. I
> used the proper (expensive as hell) Amphenol 225-22821-110 edge card
> connector for the card slot on the front panel. The pins from the two sides
> are touching each other when no card is installed, causing the module to
> short power out. Is this normal for these connectors? Is there a way to
> stretch it out? Anyone have experience with this?
> >>> Mark
> > _______________________________________________
> > Synth-diy mailing list
> > Synth-diy at synth-diy.org
> > http://synth-diy.org/mailman/listinfo/synth-diy
> > Selling or trading? Use marketplace at synth-diy.org
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> Selling or trading? Use marketplace at synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Synth-diy