[sdiy] [OT] UV solder mask vs JBWeld/Gorilla Weld

[Barry Klein]

It would be fine if it were smaller.


> On Mar 7, 2022, at 11:58 AM, Chromatest J. Pantsmaker <chromatest at azburners.org> wrote:
> 
> 
> Why not leave them secured to the thin metal base?
> 
>> On Sun, Mar 6, 2022 at 7:32 PM Barry Klein via Synth-diy <synth-diy at synth-diy.org> wrote:
>> Sorry for the OT post but I don’t frequent other electronics forums and am hoping some of you have experience with this.  I am repairing a torn flex circuit.  I have the hardest part done - I used wires from solder wick - twisted a couple together, applied solder paste on pads scraped clear on the broken traces, and have all jumpered across nicely.  But these wires have no strength. I have both flex pieces crazy glued to a thin metal base.  I intend to free them from it using a razor blade after I apply either uv soldermask or jbweld over the joints.  I’m afraid the JBWeld won’t adhere and afraid the UV solder mask won’t adhere or solidify.  Maybe it will harden if I use really thin coats but likely doesn’t adhere to the kapton.  Any advice?
>> 
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
>> http://synth-diy.org/mailman/listinfo/synth-diy
>> Selling or trading? Use marketplace at synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20220307/da0ccc31/attachment.htm>