[sdiy] [OT] UV solder mask vs JBWeld/Gorilla Weld

[Chromatest J. Pantsmaker]

Why not leave them secured to the thin metal base?

On Sun, Mar 6, 2022 at 7:32 PM Barry Klein via Synth-diy <
synth-diy at synth-diy.org> wrote:

> Sorry for the OT post but I don’t frequent other electronics forums and am
> hoping some of you have experience with this.  I am repairing a torn flex
> circuit.  I have the hardest part done - I used wires from solder wick -
> twisted a couple together, applied solder paste on pads scraped clear on
> the broken traces, and have all jumpered across nicely.  But these wires
> have no strength. I have both flex pieces crazy glued to a thin metal
> base.  I intend to free them from it using a razor blade after I apply
> either uv soldermask or jbweld over the joints.  I’m afraid the JBWeld
> won’t adhere and afraid the UV solder mask won’t adhere or solidify.  Maybe
> it will harden if I use really thin coats but likely doesn’t adhere to the
> kapton.  Any advice?
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20220307/5583447e/attachment.htm>