[sdiy] Ensoniq keyboard calibration advice?

Peter Pearson electrocontinuo at gmail.com
Thu Jun 30 21:00:01 CEST 2022


Anyone on the list have insight or advice on getting Ensoniq gear to pass
the keyboard calibration routine?  I'm looking at an ASR10 at the moment.
Cleaned the PCBs, resoldered the connectors (the only advice I've seen
online), and checked continuity everywhere relevant I could think of.  No
dice.  I haven't seen any in depth guide to dealing with this online aside
from the "one simple trick" of resoldering the connector.

Ensoniq was very stingy with schematics but the keyboard section is posted
here:

http://www.tauntek.com/ASR10.htm

Any input would be greatly appreciated.  Thanks!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20220630/88d5852a/attachment.htm>


More information about the Synth-diy mailing list