[sdiy] Issue with CD4024 Ripple Counter
ben at stuyts.nl
Sat Sep 18 00:00:27 CEST 2021
There are also quite a few blogs that do decapping and photographing of the die inside. Might be interesting if they are interested to see if it’s a fake or not.
My personal favorite, Ken Shirriff: http://www.righto.com <http://www.righto.com/>
Zeptobars: https://zeptobars.com/en/ <https://zeptobars.com/en/>
> On 17 Sep 2021, at 22:23, David G Dixon via Synth-diy <synth-diy at synth-diy.org> wrote:
> I'm tempted to dig those shitty chips out of the trash and mail them to you, to see if you fare any better, given that I'm such a noob (with 13 years of experience designing millions of dollars worth of successful synth modules).
> From: bbob [mailto:fluxmonk at gmail.com]
> Sent: Friday, September 17, 2021 12:10 PM
> To: David G Dixon
> Cc: synth-diy mailing list
> Subject: Re: [sdiy] Issue with CD4024 Ripple Counter
> [CAUTION: Non-UBC Email]
> lots of designers have used CD4000 series CMOS in SDIY circuits successfully. they have their place if used properly, and their limitations (like every technology). would be a shame if a newcomer were to be scared off of perfectly good parts just because you couldn't get it to work in your application.
> bbob drake
> On Fri, Sep 17, 2021 at 2:52 PM David G Dixon via Synth-diy <synth-diy at synth-diy.org <mailto:synth-diy at synth-diy.org>> wrote:
>> So, I went to the lab and set up a little breadboard. I put 4024 on it,
>> used my +15V and 0V rails to power it (yes, I decoupled with 104), and I
>> also set up a TL072 as a comparator driven by a triangle-wave LFO. I sent
>> the output of the comparator through a diode to have it go just between 0V
>> and +15V. I tried clocking two CD4024BEs, two CD4024BCNs, and one
>> MC14024BCP. The CD4024BCNs didn't even work. The CD4024BEs gave me some
>> really hashy looking outputs. The MC14024BCP worked perfectly. Then I
>> tested them in an ASR, with similar results.
>> So, I threw all of the CD4024s into the trash. Unfortunately, I only have
>> one MC14024B. I'm going to buy more, cuz they work well, without any
>> Lesson learned, I guess. I'm just not sure what the lesson is, other than
>> "don't use CD4XXX chips" or at least ones with edge-driven inputs.
>> Argghh!!! Why can't this stuff just work? It's a miracle that we aren't
>> still living in caves, wearing skins and hunting sabre-tooth tigers with
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org <mailto:Synth-diy at synth-diy.org>
>> http://synth-diy.org/mailman/listinfo/synth-diy <http://synth-diy.org/mailman/listinfo/synth-diy>
>> Selling or trading? Use marketplace at synth-diy.org <mailto:marketplace at synth-diy.org>
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> Selling or trading? Use marketplace at synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Synth-diy