[sdiy] PCB faceplate large hole creation?

[Roman Sowa]

Good to know, I had no idea.
So next time when I'll design tight, maze, ridiculous cutouts in my PCB, 
they will be forced to use laser cut. Gotta try it...

Roman

W dniu 2021-05-28 o 11:10, Mike Bryant pisze:
> Hi Roman
> 
> JLCPCB introduced a laser PCB cutter in 2019 as discussed in their forum and on some blogs.  But they still use mechanical milling as well and indeed their capabilities page states that this is the only offering.  But it's been quite clear on quite a few of my recent designs that the cutouts have been lasered as there are no circular corners - just two straight edges meeting sharply.   But there is no way of specifying you must have laser cutting.  Vias are always drilled as far as I can work out.
>