[sdiy] DIP LM13700 discontinuation

Steve Lenham steve at bendentech.co.uk
Fri May 28 12:44:37 CEST 2021


On 28/05/2021 10:36, Neil Johnson via Synth-diy wrote:

> Typical mixing desk these days is TL072 for all but high-gain blocks,
> where it's either transistors as the gain elements (mic pre) or 5532
> or 5534 for the sum amps.
> As an example, https://www.allen-heath.com/ahproducts/wz14-4-2/

Bearing in mind the rate of change in the electronics industry, it's 
worth acknowledging that this has been the case for 30 YEARS or more! I 
was working on broadcast mixers back in the early '90s and the opamp 
lineup was exactly the same. Those devices just tick most if not all the 
boxes for a wide range of audio applications, and the multiple sources 
and ubiquity they have built up helps prolong the situation.

Yes, there are modern alternatives but the improvements are usually 
marginal and often offset by cost or single-sourcing. The NE5532 shows 
its age a bit with its power consumption and tendency to go unstable 
without some decoupling caps nearby to keep it company and I admit I 
tend to use the MC33178 in that position now, but the TL07x is still a 
go-to device.

Cheers,

Steve L.
Benden Sound technology



More information about the Synth-diy mailing list