[sdiy] Reply to list (was: DIP LM13700 discontinuation)

[Ben Stuyts]

As far as I remember, it has always been the case that a simple Reply would go to the sender and not to the list. This has not changed recently. I think this has been discussed several times over the past decades and this was the preferred behaviour.

Ben


> On 21 May 2021, at 01:21, thresholdpeople <thresholdpeople at protonmail.com> wrote:
> 
> The emails arriving with most senders labeled as synth-diy at synth-diy.org persists though, and it is only when clicking reply all, or eventually in quoted headers can you see the recipient - for instance when checking more info for sender details, it's still addressed as synth-diy as the email. There are a few folks whose names show up, but for most it's somewhat anonymized... even more problematic as there's a chunk of folks who don't have a signature or drop their names at the bottom (i'm guilty of this too!).. hard to know who is saying what sometimes.
> 
> -boris
> 
> ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
> 
> On Thursday, May 20th, 2021 at 2:50 PM, cheater cheater via Synth-diy <synth-diy at synth-diy.org> wrote:
> 
>> David's problem has been apparently fixed (see parallel thread).
>> 
>> On Thu, May 20, 2021 at 5:48 PM Ben Stuyts ben at stuyts.nl wrote:
>> 
>>> Correcting myself: I should have written DMARC, not DKIM below. For those wanting to know more about the settings: https://wiki.list.org/DEV/DMARC
>>> 
>>> Ben
>>> 
>>> On 20 May 2021, at 16:49, Ben Stuyts ben at stuyts.nl wrote:
>>> 
>>> David,
>>> 
>>> On 19 May 2021, at 22:10, David G Dixon via Synth-diy synth-diy at synth-diy.org wrote:
>>> 
>>> Finally, why was the way email addresses are handled changed in this forum? I used to be able to just click "Reply All" and it would go to the whole list. Not anymore. Now I have to find the list name in my address book and add it manually. Please change it back.
>>> 
>>> I think it is related to the following: Unfortunately a change was necessary with regards to DKIM signed messages. More and more ISP’s would block or otherwise fail to deliver messages if those came from the list. So now, the list rewrites those as FROM: synth-diy at synth-diy.org and adds a REPLY-TO: original.sender at some.where.
>>> 
>>> On my Mac, I can just click the Reply All button and it goes to the sender and the list.
>>> 
>>> It was discussed here: http://synth-diy.org/pipermail/synth-diy/2021-April/175907.html
>>> 
>>> Ben
>>> 
>>> Synth-diy mailing list
>>> 
>>> Synth-diy at synth-diy.org
>>> 
>>> http://synth-diy.org/mailman/listinfo/synth-diy
>>> 
>>> Selling or trading? Use marketplace at synth-diy.org
>>> 
>>> Synth-diy mailing list
>>> 
>>> Synth-diy at synth-diy.org
>>> 
>>> http://synth-diy.org/mailman/listinfo/synth-diy
>>> 
>>> Selling or trading? Use marketplace at synth-diy.org
>> 
>> Synth-diy mailing list
>> 
>> Synth-diy at synth-diy.org
>> 
>> http://synth-diy.org/mailman/listinfo/synth-diy
>> 
>> Selling or trading? Use marketplace at synth-diy.org
>