[sdiy] How to use an analog time-domain multiplexer?

[Mike Bryant]

That's true, but that's a monosynth.  If you tried replicating a very complex mono-patch sixteen times all you would have is a wall of noise.    Some things like amplitude and frequency modulation can be left on a single basis.  Envelopes are worth keeping separate though, but you need some way of doing a master edit, followed by deviations for the other harmonics/overtones.  But again you are getting into digital again as this really becomes a processor job.


-----Original Message-----
From: Synth-diy [mailto:synth-diy-bounces at synth-diy.org] On Behalf Of cheater cheater via Synth-diy
Sent: 04 June 2021 13:51
To: Neil Johnson
Cc: synth-diy
Subject: Re: [sdiy] How to use an analog time-domain multiplexer?

Dude Neil even a relatively small modular has 150 I/O - that really adds up! I've taken the Doepfer pre-built systems as an example.

On Fri, Jun 4, 2021 at 1:34 PM Neil Johnson via Synth-diy <synth-diy at synth-diy.org> wrote:
>
> cheater cheater wrote:
> > OK, but it's difficult to find ADC and DAC cheap enough to do this.
> > The ADC and DAC will end up costing loads.
>
> This is synth-diy so who cares about the cost?  It's not like you're 
> going to be building hundreds or thousands where every dollar counts.
>
> Neil
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
_______________________________________________
Synth-diy mailing list
Synth-diy at synth-diy.org
http://synth-diy.org/mailman/listinfo/synth-diy
Selling or trading? Use marketplace at synth-diy.org