[sdiy] Quantizer project.. incoming CV's switching point to change to quantized output CV's ...

Jean-Pierre Desrochers jpdesroc at oricom.ca
Sun Jul 4 19:35:10 CEST 2021

I'm starting a CV quantizer design and am wondering

about the following things:


Let's assume a normal quantized semi-tone scale:

All the incoming CV's are quantized to semi-tones like this:

incoming CV 'around' C, output quantized CV -> C

incoming CV 'around' C#, output quantized CV -> C#

incoming CV 'around' D, output quantized CV -> D

and so on..

12 equally spaced output quantized intervals. OK.


But if the quantized scale output is a TRIAD like

C-E-G-C-E-G-C, etc... ( 3 quantized intervals)


where are the switching bounderies of each incoming note CV's 

to change to the next outputed quantized note ?

This question is for ascending and/or descending notes..


Same question for a quantized PENTATONIC major scale output like

C-D#-F-G-A#-C-D#-F-G-A#-C, etc.. ( 5 quantized intervals)


I would think of dividing the octave range with 

equal intervals with the number of intervals

inside the actual quantized scale..

For example: 


That's 3 intervals

1 octave = 1 volt

so 1volt/3 intervals = 0.333v between each quantized notes (??)




PENTATONIC major scale C-D#-F-G-A#-C

That's 5 intervals

1 octave = 1 volt

so 1volt/5 intervals = 0.20v between each quantized notes (??)


But... I don't think that is working this way..

I think I must keep the incoming CV interval sizes

and use them for the quantized switch points.. (???)


Your opinion on that ??

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20210704/b60f94c0/attachment.htm>

More information about the Synth-diy mailing list