[sdiy] Microchip.. for futur projects, choice to do.. PICs or Arduino

matt holland matt at mattholland.org
Thu Feb 25 19:18:01 CET 2021


These tools are also all available on Mac as well if that's your jam.

On Thu, Feb 25, 2021 at 12:18 AM Vladimir Pantelic <vladoman at gmail.com>
wrote:

> apart from above mentioned command line tools, ST provided software like
> Cube
> IDE (Eclipse based) and Cube MX run perfectly fine under Linux, you can
> also
> flash and debug from Cube IDE just fine. you can even update the STLINK
> debugger
> firmware from Linux.
>
> CubeMX is a really nice tool to play with pin assignments and the clock
> setup.
> the code it generates although horrible to look at is quite nice as a
> starting
> point for your own stuff.
>
>
> On 2/24/21 10:54 PM, Liam Wall wrote:
> > Not sure if its changed, but last time i tried to use an STM discovery
> board all
> > the ST tools seemed to be windows only. That may or may not be a
> consideration
> > for you.
> >
> > On Wed, 24 Feb 2021, 21:50 Ben Stuyts, <ben at stuyts.nl <mailto:
> ben at stuyts.nl>> wrote
> >
> >
> >     Both Microchip and ST boards have an on-board debugger. They have
> free
> >     development environments with support for debugging.
> >
> >
> > _______________________________________________
> > Synth-diy mailing list
> > Synth-diy at synth-diy.org
> > http://synth-diy.org/mailman/listinfo/synth-diy
> > Selling or trading? Use marketplace at synth-diy.org
> >
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20210225/5fdbf5cf/attachment.htm>


More information about the Synth-diy mailing list