[sdiy] Custom Enclosure service?

Mike Bryant mbryant at futurehorizons.com
Mon Aug 30 17:50:02 CEST 2021


Have a look at Lincoln Binns.  You’ll possibly recognise some of their cases as other people stock them, but they are the manufacturers and will do semi-custom variants.

https://lincolnbinns.com/



From: Synth-diy [mailto:synth-diy-bounces at synth-diy.org] On Behalf Of Spiros Makris via Synth-diy
Sent: 30 August 2021 12:51
To: synth-diy mailing list
Subject: [sdiy] Custom Enclosure service?

Hello list,
I am looking for someone who can make a metal enclosure for me, to fit a device with buttons, jacks etc. I think I have enough budget available to delegate this to someone else who'll do it better than me (metalworking is really not my strong point).

Specs are still a bit vague, I expect the size to be around 20x15cm, with holes and cutouts on two of the sides (top and back). Some method of marking the front panel with letters will be nice too. I'm looking for just a couple of units. The specific method of manufacture doesn't concern me, but I suppose a sheet metal enclosure or routing an off the self box would be the most accessible options for me?
I guess I'm looking for suggestions of either professionals who offer this service for small quantities or any fellow hobbyist who has the required tools and might be willing to take up a small project.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20210830/f6a3a434/attachment.htm>


More information about the Synth-diy mailing list