[sdiy] Custom Enclosure service?

Jozsef Baksay topylista1 at topybear.hu
Mon Aug 30 17:09:16 CEST 2021

Vero Technologies ?
Wide range of aluminium enclosures and modification serveice:.



On 2021. 08. 30. 13:50, Spiros Makris via Synth-diy wrote:
> Hello list,
> I am looking for someone who can make a metal enclosure for me, to fit 
> a device with buttons, jacks etc. I think I have enough budget 
> available to delegate this to someone else who'll do it better than me 
> (metalworking is really not my strong point).
> Specs are still a bit vague, I expect the size to be around 20x15cm, 
> with holes and cutouts on two of the sides (top and back). Some method 
> of marking the front panel with letters will be nice too. I'm looking 
> for just a couple of units. The specific method of manufacture doesn't 
> concern me, but I suppose a sheet metal enclosure or routing an off 
> the self box would be the most accessible options for me?
> I guess I'm looking for suggestions of either professionals who offer 
> this service for small quantities or any fellow hobbyist who has the 
> required tools and might be willing to take up a small project.

More information about the Synth-diy mailing list