[sdiy] Custom Enclosure service?

Ben Riggs benalog1977 at gmail.com
Mon Aug 30 15:59:34 CEST 2021

Front Panel Express do enclosures. I’ve never used them for enclosures, only front panels, but they are pretty good.

The only thing I’d advise against is placing anything on the reverse side if it needs to align with the front machining.

Sent from my iPhone

> On 30 Aug 2021, at 1:53 pm, Spiros Makris via Synth-diy <synth-diy at synth-diy.org> wrote:
> Hello list,
> I am looking for someone who can make a metal enclosure for me, to fit a device with buttons, jacks etc. I think I have enough budget available to delegate this to someone else who'll do it better than me (metalworking is really not my strong point). 
> Specs are still a bit vague, I expect the size to be around 20x15cm, with holes and cutouts on two of the sides (top and back). Some method of marking the front panel with letters will be nice too. I'm looking for just a couple of units. The specific method of manufacture doesn't concern me, but I suppose a sheet metal enclosure or routing an off the self box would be the most accessible options for me?
> I guess I'm looking for suggestions of either professionals who offer this service for small quantities or any fellow hobbyist who has the required tools and might be willing to take up a small project.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org

More information about the Synth-diy mailing list