[sdiy] Custom Enclosure service?

bbob fluxmonk at gmail.com
Mon Aug 30 14:56:41 CEST 2021


I haven't used them, but tayda offers custom drilling on pedal-sized cast
aluminum enclosures:
https://www.taydaelectronics.com/hardware/enclosures/enclosure-custom-drill-service.html



bbob
https://www.fluxmonkey.com

On Mon, Aug 30, 2021 at 7:54 AM Spiros Makris via Synth-diy <
synth-diy at synth-diy.org> wrote:

> Hello list,
> I am looking for someone who can make a metal enclosure for me, to fit a
> device with buttons, jacks etc. I think I have enough budget available to
> delegate this to someone else who'll do it better than me (metalworking is
> really not my strong point).
>
> Specs are still a bit vague, I expect the size to be around 20x15cm, with
> holes and cutouts on two of the sides (top and back). Some method of
> marking the front panel with letters will be nice too. I'm looking for just
> a couple of units. The specific method of manufacture doesn't concern me,
> but I suppose a sheet metal enclosure or routing an off the self box would
> be the most accessible options for me?
> I guess I'm looking for suggestions of either professionals who offer this
> service for small quantities or any fellow hobbyist who has the required
> tools and might be willing to take up a small project.
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
> Selling or trading? Use marketplace at synth-diy.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20210830/0ceb2c22/attachment.htm>


More information about the Synth-diy mailing list