[sdiy] Designing front panels for synths

[Spiros Makris]

Wow, now that's extreme! Did you buy the board material raw in bulk or is
this ordered from some fabhouse? I can't help but think that it would be
rather expensive to get this from a fabricator.

On Thu, Oct 15, 2020 at 2:01 PM Roman Sowa <modular at go2.pl> wrote:

> Here you are, 90kB picture taken just now.
> The bottom base plate, end cheeks and front bar are made of chipboard.
> Everything else is PCB (except the keys obviously).
> The sad thing is also seen in this picture, it's standing in the storage
> among other sad keyboards :(
>
> Roman
>
> W dniu 2020-10-15 o 11:41, Adam Inglis (sdiy) pisze:
> >
> >
> >> On 15 Oct 2020, at 6:44 pm, Roman Sowa <modular at go2.pl
> >> <mailto:modular at go2.pl>> wrote:
> >>
> >> The biggest thing I made out of PCB was 140cm long cover for DIY
> >> keyboard and it feels almost like made out of 1mm steel, and because
> >> it's easily solderable, I could build fancy mounting system, so there
> >> are absolutely no screws on top.
> >
> >
> > OK Roman, you can’t get away with that statement … without a picture!!
> >   C’mon, we need evidence...
> >
> > A
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20201015/ab0e34a4/attachment.htm>