[sdiy] Designing front panels for synths

[Davide Romboli]

if it has not already been said .. here is an inkscape plugin to draw
panels ... maybe it can help
https://synthpanels.design/

Il giorno mer 14 ott 2020 alle ore 10:19 Gordonjcp <gordonjcp at gjcp.net> ha
scritto:

> On Tue, Oct 13, 2020 at 03:09:37PM -0700, MTG wrote:
> >
> > This is how it starts. :-)  Once upon a time I had a guy upset that a
> little
> > perf-board project I did for him didn't have the resistor color codes all
> > running the same way. It had never crossed my mind. Now I'm cursed and
> > solder my PTH resistors as if they were polaraized. And maybe I'll just
> pass
> > that curse on to all of you.
> >
>
> I thought it was just me.  I was kicking myself when I realised I'd
> soldered the thoroughly buried series resistors for the headphone outputs
> on my VS1680 "opposite ways round", but by that point I figured no-one
> would ever see them again once all 427 screws were back in.
>
> > Anyway, I am firmly in the camp of those that have responded so far.
> Avant
> > garde front panels would hurt my engineering brain too much.
>
> Some of them are really horrible.
>
> What I'm looking for is some basic hints on making panels look balanced
> and proportionate.
>
> --
> Gordonjcp
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>


-- 
ciao Davide
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20201014/86d6ad81/attachment.htm>