[sdiy] Designing front panels for synths

[Jay Schwichtenberg]

Or so you think.

For my stuff when I do SMD resistors I don't go smaller than 805s and 
put the numbers all the same way. Makes it a lot easier if you have to 
trouble shoot the boards.

Jay S.

On 10/13/2020 3:20 PM, Pete Hartman wrote:
>
>
> On Tue, Oct 13, 2020 at 5:13 PM MTG <grant at musictechnologiesgroup.com 
> <mailto:grant at musictechnologiesgroup.com>> wrote:
>
>
>     On 10/13/2020 2:48 PM, David G Dixon wrote:
>     > Yeah, Colin, that never bothered me in the slightest. In fact, I
>     have
>     > never noticed it until you mentioned it, and I must confess that
>     the
>
>     This is how it starts. :-)  Once upon a time I had a guy upset that a
>     little perf-board project I did for him didn't have the resistor
>     color
>     codes all running the same way. It had never crossed my mind. Now I'm
>     cursed and solder my PTH resistors as if they were polaraized. And
>     maybe
>     I'll just pass that curse on to all of you.
>
>
>
> The good news is, SMD resistors are so tiny nobody will ever notice ;)
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20201013/fed855aa/attachment.htm>