[sdiy] MIDI and ESD protection

Ullrich Peter Peter.Ullrich at kapsch.net
Wed Feb 5 22:57:12 CET 2020


Here you can find many other alternative ESD protection diodes:

https://eu.mouser.com/Circuit-Protection/ESD-Suppressors-TVS-Diodes/_/N-jy72?P=1yh8o3j

Ciao
peter

http://www.ullrich.at.tt
________________________________________
Von: Synth-diy <synth-diy-bounces at synth-diy.org> im Auftrag von Julian <elfenjunge at gmx.net>
Gesendet: Mittwoch, 5. Februar 2020 22:47
An: synth-diy at synth-diy.org
Betreff: [sdiy] MIDI and ESD protection

I wonder how I should go about protecting a 3.3V MIDI out circuit
against 8kV contact ESD.
When I use a TVS with 5V working voltage, most of the time I still have
16-20V clamping voltage over the diode for 8kV contact pulses.
With the 3.3V setup I only have a 10Ohm resistor limiting the current to
my UART TX pin.
with a 74hc14 as driver/buffer I can sink +/-20mA, but with 16V at 10 ohm I
have much more to sink.
I can't find anything about MIDI and ESD in the official specs or other
sources.

I'm new to ESD. So do I miss something? Is the short pulse time not
enough to fry the internal clamping diodes of a 74HC chip?

Any insights are welcome!

Julian

_______________________________________________
Synth-diy mailing list
Synth-diy at synth-diy.org
http://synth-diy.org/mailman/listinfo/synth-diy



The information contained in this e-mail message is privileged and confidential and is for the exclusive use of the addressee. The person who receives this message and who is not the addressee, one of his employees or an agent entitled to hand it over to the addressee, is informed that he may not use, disclose or reproduce the contents thereof, and is kindly asked to notify the sender and delete the e-mail immediately.





More information about the Synth-diy mailing list