[sdiy] Homemade synth clone

Tom Wiltshire tom at electricdruid.net
Fri Feb 15 18:14:01 CET 2019


Pete is dead right. NOISE 1B runs on 5V, so produces a analog noise level of 2-3V or so. MN5837 ran on 0V and -15V, so produced roughly three times the output. But fixing this usually involves just a simple gain resistor change.

Tom

==================
       Electric Druid
Synth & Stompbox DIY
==================


> On 15 Feb 2019, at 15:15, Pete Hartman <pete.hartman at gmail.com> wrote:
> 
> 
> 
> On Fri, Feb 15, 2019 at 8:07 AM Luís Marka <luis.marka at terra.com.br> wrote:
>  Also, the noise generator MM5837 seems to be made 
> of Unobtanium. Will use an Electrodruid NOISE 1B chip instead!
> 
> 
> It works, but you should note that the levels are (probably) different so it is likely you'll need to make adjustments in the section that processes the noise.
> 
> On the Roman F Source of Uncertainty, for example, had to bump a couple resistors to increase the gain and get the noise range back to what it should be.
> 
> 
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy




More information about the Synth-diy mailing list