[sdiy] Mute solution?

Roman modular at go2.pl
Sat May 26 19:51:06 CEST 2018


You're right, I was thinking too fast with a glass of something.  Zero-cross switching is equivalent of amplitude modulation of the signal and steep edged pulse, so obviously the product will contain all the signal images shifted by all harmonics of the pulse edge. Bad idea.   So then the only suitable idea is some kind of envelope. Gating a FET with RC network should give some gradual fading out, only a matter of selecting time constant.   And yet another idea to make it faster for higher frequencies and slower at the low end - make two such mute citrcuits pulling down one signal line - one FET gets the signal on its drain via capacitor, and its muting RC time constant is short, so high frequrncies are muted quickly, while low end doesn't care about that little cap and carries on. Then second FET hits in, with longer time constant RC. Without any cap it clamps everything to GND.    Roman   Dnia 26 maja 2018 10:31 Andre Majorel <  aym-htnys at teaser.fr > napisał(a):  On 2018-05-24 20:47 +0200, Roman wrote:   How about detecting zero-zrossing and shutting down the audio  with clamping MOSFET or whatever when signal is no more than  1mV away from GND? No clicking.   If you want to hear what switching at zero-crossings sounds  like, play the WAV file at   www.teaser.fr www.teaser.fr   The signal being switched is a low-frequency sine so as not to  mask the artefact. On a signal with more high frequency content,  the artefact would be less conspicuous.   --  André Majorel  www.teaser.fr www.teaser.fr  ______________________________  Synth-diy mailing list   Synth-diy at synth-diy.org  synth-diy.org synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20180526/d85d1135/attachment.html>


More information about the Synth-diy mailing list