[sdiy] Band-Pass Filter with CV control of Frequency Cut-off?

[bbob]

i'm fond of Ken's simple bandpass: http://www.cgs.
synth.net/modules/cgs30_bpf.html, I have a couple voicing modules w/ 3 in
parallel.  I guess you could vactrolize the frequency pot, though i'm not
sure if it's all that much simpler in the end.

b

On Sat, Mar 31, 2018 at 8:14 AM, Justin Owen <juzowen at gmail.com> wrote:

> Hello,
>
> Can anyone point me to some schems of a reasonably simple, analogue
> band-pass filter with CV control over the frequency cutoff - that *isn't*
> the well-established two pole multi-mode architecture and I guess - at the
> other end of the scale - isn't a passive filter with the resistor/s
> replaced by a vactrol.
>
> I'm looking for something to use as part of a feedback effect I've been
> tinkering with - so I don't need anything too fancy or highly-specced but
> the standard two pole multi-mode is currently more complex than my needs.
>
> Is there such a thing?
>
> Thanks!
>
> / Justin
>
>
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20180331/458516c8/attachment.htm>