[sdiy] Eagle for PCB Layout

[Tim Ressel]

I recently had an opportunity to use diptrace. It didn't seem to allow 
for highlighting a part in the schematic and showing the corresponding 
part in the layout. Perhaps it was a noob oversight?

--timmers


On 6/30/2018 2:31 PM, Tom Wiltshire wrote:
> +1 for Diptrace. Does the job, reasonably priced, not a lot of stupid quirks.
>
> Designing your own libraries for every single part you use is an admission of failure in my view. Any decent package should have the common stuff in a reliable form or you can forget it. Ok, not everything is going to have CA3089 or SSM2047, and that’s ok, but I expect to find CD4013 (for example) without issues. Your priorities may differ!
>
> T.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy

-- 
--Tim Ressel
Circuit Abbey
timr at circuitabbey.com