[sdiy] Behringer Model D PCB

rsdio at audiobanshee.com rsdio at audiobanshee.com
Tue Feb 20 10:31:05 CET 2018


In addition, they probably order the processor chips pre-programmed with their firmware, so the only reason they would even need the header is on the bench. In other words, it’s probably not used during assembly.

My question is why it’s even populated.

Brian


On Feb 20, 2018, at 1:29 AM, rsdio at audiobanshee.com wrote:
> You mean, “X19” ?
> 
> It’s probably on the front because you can’t lay the board flat with it out of the case and actually use it unless it’s on the front with everything else.
> 
> Of course, the Eurorack-compatible power connector at “X23” seems to have the same problem, except that it can at least hang off the edge of the table.
> 
> Brian
> 
> On Feb 20, 2018, at 1:19 AM, Tom Wiltshire <tom at electricdruid.net> wrote:
>> I wonder why they put that programming header on the front not the back?
> 




More information about the Synth-diy mailing list