[sdiy] top soldering through hole

Quincas Moreira quincas at gmail.com
Wed Feb 14 15:15:43 CET 2018

I’ve never cleaned a board, ever... Maybe I’m using no clean solder and didn’t even know it, I just never felt the need. My builds look clean enough to me. Am I trippin’?

Sent from my iPhone

> On Feb 14, 2018, at 07:33, Pete Hartman <pete.hartman at gmail.com> wrote:
>> On Wed, Feb 14, 2018 at 7:25 AM, Mattias Rickardsson <mr at analogue.org> wrote:
>> Top side is much simpler, I'll never go back - but probably a bit trickier to get clean from flux etc?
>  I think this is the main reason I still primarily bottom solder, but I check my joints and if I have ones that didn't wick up to the top I'll touch them up with no-clean.
> Pete
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20180214/842b3846/attachment.html>

More information about the Synth-diy mailing list