[sdiy] Parts going out of module panel

[Vladimir Pantelic]

but then alpha pots with the little legs are 10mm too...

On Mon, Apr 30, 2018, 12:58 electronicpresskit <electronicpresskit at gmail.com>
wrote:

>
> > On Apr 30, 2018, at 12:33 PM, paula at synth.net wrote:
> >
> >>> For module connectors (assuming you're talking euro module) I'd go with
> >>> the THONKICONN (which is about 9mm from memory) from Thonk.co.uk
> >> 10mm :)
> >
> > 9mm from base of connector to back of front panel ;)
>
> the datasheet is a bit unclear...the main body is 9mm, but there is a
> small 1mm ridge on two sides of the metal. so if the panel hole is large
> enough, it can be 9mm, but it might be 10mm if your hole tolerances are
> small enough.
>
> I discovered this the hard way.
>
> epk
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20180430/3767db71/attachment.htm>