[sdiy] Parts going out of module panel

electronicpresskit electronicpresskit at gmail.com
Mon Apr 30 12:58:56 CEST 2018

> On Apr 30, 2018, at 12:33 PM, paula at synth.net wrote:
>>> For module connectors (assuming you're talking euro module) I'd go with
>>> the THONKICONN (which is about 9mm from memory) from Thonk.co.uk
>> 10mm :)
> 9mm from base of connector to back of front panel ;)

the datasheet is a bit unclear...the main body is 9mm, but there is a small 1mm ridge on two sides of the metal. so if the panel hole is large enough, it can be 9mm, but it might be 10mm if your hole tolerances are small enough.

I discovered this the hard way.


More information about the Synth-diy mailing list