[sdiy] Name this connector...

[Tim Ressel]

My raw keyboard has ribbon cables on it. I just need the sockets for a 
new board. I get to make a keyboard scanner! Yay!

--tr


On 9/13/2017 12:11 AM, Matthias Herrmann wrote:
> That is the correct one. Don't be fooled by the footprint in the datasheet, the pin has an offset to the actual contact..
>
> But you wouldn't you just want the header for that?
> http://www.mouser.com/ProductDetail/TE-Connectivity/8-215083-6/?qs=sGAEpiMZZMs%252bGHln7q6pm8SOCK6aAoLgd7tv9X7QTQE%3d
>
> On the other side of the flat cable you could use whatever you normally use...
>
>
> -----Original Message-----
> From: Synth-diy [mailto:synth-diy-bounces at synth-diy.org] On Behalf Of Tim Ressel
> Sent: Saturday, September 09, 2017 9:47 PM
> To: SYNTH DIY <synth-diy at synth-diy.org>
> Subject: [sdiy] Name this connector...
>
> Hi,
>
> I have a raw keyboard that I want to re-use. It uses these connectors:
>
> https://urldefense.proofpoint.com/v2/url?u=https-3A__imgur.com_a_i5Sw6&d=DwICAg&c=P3aKjizb3qsxp0SERaL2sw&r=Wo0ERRj3NwEx1MVmRi7Tj3kJss6CkyI0BMe1OujCfok&m=RRqQu7KeqEtkyGrcmMEPVmiwjo5ewq88vlCv239osHk&s=jJEsYjjVXUinQgTPIUCfgodVcMStGs6BEAnfrmEX4b8&e=
>
> I can't find them. I found this:
>
> Mouser 571-1-215079-6
>
> But it appears they are backwards i.e. first pin is on bottom left whereas mine is top left.
>
> Help?
>
> --
> --Tim Ressel
> Circuit Abbey
> timr at circuitabbey.com
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> https://urldefense.proofpoint.com/v2/url?u=http-3A__synth-2Ddiy.org_mailman_listinfo_synth-2Ddiy&d=DwICAg&c=P3aKjizb3qsxp0SERaL2sw&r=Wo0ERRj3NwEx1MVmRi7Tj3kJss6CkyI0BMe1OujCfok&m=RRqQu7KeqEtkyGrcmMEPVmiwjo5ewq88vlCv239osHk&s=tC8eVpoNbzd2GOrvaqnFjCu0qXbqo3FMp-cQzv_w7CM&e=
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>

-- 
--Tim Ressel
Circuit Abbey
timr at circuitabbey.com