[sdiy] pros and cons of SMT in DIY

[Roman Sowa]

The wires are so thin that it wouldn't go off while soldering the other 
side, even if I wanted them to go off.

Roman

W dniu 2017-05-24 o 13:03, Michael Zacherl pisze:
>
> On 24.May 2017, at 11:21 , Roman Sowa <modular at go2.pl> wrote:
>
>> Talking about crazy SMD prototyping, here's an example to what I did with 3x3mm 10-leads DFN package. I used thin magnet wire to actually add leads to it. When done, it looked like a cool little spider.
>
> :)
> won’t that go off when soldering the “spider” to the PCB? Meaning heat-conduction loosening the chip.
>
> m.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>