[sdiy] Roland M16C / M64C memory module - Connectors

[MTG]

It's the same receiving connector (receptacle) on Yamaha DX7 and Kawai 
stuff from that era.  I probably have one somewhere I could take a photo 
of. I don't know how much of the contact pressure, if any, comes from 
that end.

You can get an idea from this:
www.ebay.com/itm/Yamaha-ADP1-DX-Cartridge-Adapter-DX7II-D-FD-DX11-RX5-RX7-TX802-DX7-/192236650180


On 7/18/2017 1:57 PM, rsdio at audiobanshee.com wrote:
> By the way, that photo makes it look like the total thickness is much greater than the standard 62 mil, but there is spring-loading that allows significant compression. I'd like to see the receiving connector, too, because if it isn't spring-loaded then forcing an incompressible PCB into the connector is not going to last very long. Wouldn't want to ruin a JX8P just to make a cheap cart!