[sdiy] Need help with a SMD kit (OT?)

[Elain Klopke]

Hey list,

I bought the Elements diy kit from Synthcube and managed to get all the
surface mount components attached using solder paste, a tiny syringe, and a
hot plate. Everything melted nicely and I only burnt the solder mask a bit
because I wasn't quick enough getting it off the hot plate, but the copper
traces appear to be still attached to the board so I'm not too worried.

And then the problems started. I let the board cool down and then started
going about eliminating solder bridges on a couple of the ICs. I cleaned up
one side of the microcontroller and then made the other three worse. I got
one chip that was a little crooked seated properly and then another popped
free and I couldn't get it resoldered.

I've stepped away from the kit so I don't do more damage or throw it
against the wall in frustration.

Is there anyone experienced in surface mount soldering (preferably in the
US) that would be willing to fix this mess for me. I'm way out of my depth
and am willing to pay postage both ways and a fee for your time.

Thanks in advance.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20170718/299390f5/attachment.htm>