[sdiy] sin/cos pot

[Neil Johnson]

Hi,

Paula wrote:
> I guess, though not tested, you could go a step further and use edge detection on both channels and both edges on both channels giving you 96PPQN from a 24PPQN encoder, though I would expect switch bounce to cause more of a problem at this resolution.

Umm.. that's the normal way of reading a quadrature encoder.  Sure,
you can use only half or quarter of the edges, but I've always used
encoders in the full all-four-edges mode.  Heck, even microcontrollers
with quadrature encoder support (usually in one of the timers) support
this mode.

Neil
-- 
http://www.njohnson.co.uk