[sdiy] Crumar bit one EPROM .bin anyone

[Maarten]

Hi Luc,

I thought these parameters where only listed on the bit-1 and bit-99. 
You can send omni off over midi and I will respond only to channel one.
Cheers,
Maarten

Op 23-1-2017 om 21:23 schreef Luc Van Den Bosch:
> Hi all, I have a Crumar bit one and that synth has the annoying
> “feature” to be in midi omni mode when you switch it on.
>
> It should be possible to disable omni with parameter 64 and 65 but that
> doesn’t work on my bit one which apparently means I have an older
> version of the firmware (parameter 64 and 65 don’t show any value and it
> should be 1 or 0).
>
> Does anyone have the binaries for the 2 EPROM to share?
>
> I found downloads here:
> http://dbwbp.com/index.php/9-misc/37-synth-eprom-dumps but the version
> seems to be the same because also  with this version parameter 64 and 65
> are not shown.
>
>
>
> Thanks!
>
> Luc
>
>
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>